Availability: | |
---|---|
Quantity: | |
TR200875
TRUMONY
Electromobile/electric vehicle/New energy automobile/vehicle/car battery cooling widely use our aluminum brazing water cooling sheets/plates.
We are not only manufacturer, but also design and development company, better heat exchanger solutions are our speciality.
1.Alloy State:
2.Chemical Composition(%)
Core Alloy:3003
Element | Si | Fe | Cu | Mn | Mg | Cr | Zn | Bi | Zr | Ti | Al |
Max | 0.6 | 0.7 | 0.20 | 1.5 | - | 0.05 | 0.10 | 0.05 | - | - | Rem |
Min | - | - | 0.05 | 1.0 | - | - | - | - | - | - | - |
4.Mechnical Properties
Properties | Rp0.2(MPa) | Rm(MPa) | A50(%) | Clad 1 ratio(%) | Clad 2 ratio(%) |
Max | - | 135 | - | - | - |
Min | 35 | 95 | 10 | - | - |
FAQ:
Q: What is your terms of payment ?
A: Normally 30% TT in advance, balance paid before shipment.
Q: How long does it take for samples and mass production?
A: Usually it will take 15-20 days for new moulds and free samples (within 5 kg),; after confirmation, 25-30 days for mass production.
Q:OEM/ODM available?
A:Yes,we can!
Q: Can you assist in design?
A: Yes, we can! We have a strong and experienced design team.
Q:Could you provide sample?
A:Yes, We are honored to offer you samples for quality check.
Q:Is sample order accepted?
A:Yes,we accept sample order and we can provide design service!
Electromobile/electric vehicle/New energy automobile/vehicle/car battery cooling widely use our aluminum brazing water cooling sheets/plates.
We are not only manufacturer, but also design and development company, better heat exchanger solutions are our speciality.
1.Alloy State:
2.Chemical Composition(%)
Core Alloy:3003
Element | Si | Fe | Cu | Mn | Mg | Cr | Zn | Bi | Zr | Ti | Al |
Max | 0.6 | 0.7 | 0.20 | 1.5 | - | 0.05 | 0.10 | 0.05 | - | - | Rem |
Min | - | - | 0.05 | 1.0 | - | - | - | - | - | - | - |
4.Mechnical Properties
Properties | Rp0.2(MPa) | Rm(MPa) | A50(%) | Clad 1 ratio(%) | Clad 2 ratio(%) |
Max | - | 135 | - | - | - |
Min | 35 | 95 | 10 | - | - |
FAQ:
Q: What is your terms of payment ?
A: Normally 30% TT in advance, balance paid before shipment.
Q: How long does it take for samples and mass production?
A: Usually it will take 15-20 days for new moulds and free samples (within 5 kg),; after confirmation, 25-30 days for mass production.
Q:OEM/ODM available?
A:Yes,we can!
Q: Can you assist in design?
A: Yes, we can! We have a strong and experienced design team.
Q:Could you provide sample?
A:Yes, We are honored to offer you samples for quality check.
Q:Is sample order accepted?
A:Yes,we accept sample order and we can provide design service!